Episode 15 Words of Wisdom Worth Hearing and Implementing by Dr Florian Thieringer
Dr. Florian Thieringer is a Senior Cranio-Maxillofacial Surgeon, a medical 3D Printing expert at the University Hospital Basel, Switzerland. He is the head of the Swiss Medical Additive\xa0 Manufacturing Research Group and the vice-chair of the AO Development Commission. He is also the editor-in-chief of Cranio Maxillofacial Trauma Reconstruction Open Journal. He needs no Introduction in the craniomaxillofacial fraternity.
\xa0
Learn more about 3D Printing on www.surgeonsin3dprinting.com.
\xa0
Subscribe\xa0
\xa0
Apple I\xa0 Google I\xa0 Amazon Music I Spotify I Gaana
\xa0
Resources:
\xa0
Join the Facebook page Surgeons in 3D Printing!
\xa0
Visit the website: www.surgeonsin3dprinting.com.
\xa0
Three Takeaways
- 3D Printing is an exciting technology to be used for patient care.
- Start with basic printers but one needs to standardize their workflow and processes in the long run.
- Regulatory concerns are tricky but need to be taken care of.
\xa0
Sponsors:
Reconstructive Healthcare Solutions Private Ltd.
\xa0
Show Notes
\xa0
Today\u2019s AudioTraining\xa0
\xa0
Words of Wisdom Worth Hearing and Implementing by Dr Florian Thieringer
\xa0
\xa0
[1:55]\xa0
Dr. Florian shares his entire experience of how he started with Medical 3D Printing in his long career.
[4.01]
Dr. Florian shares his excitement about the possibility of holding the anatomy of the patients in hand.
[4:46]
Dr. Florian shares how he started the 3D PrintLab in University hospital, Basel.
[6:40]
Dr. Florian shares various applications they perform at the 3D Print Lab.
[8:01]\xa0
Dr. Florian shares how he had wet his hands with the 3D Printing Technology and later built his lab.
\xa0
[9:02]
Dr. Florian shares various examples of the research conducted in the 3D Print Lab at Basel.
[1:15]
Dr. Florian shares the research need to improve workflows which are needed for every aspect
[14:20]
Dr. Florian shares the need for mindfulness, openness, and reimbursement strategies for better penetration of the technology.
\xa0
[16:17]
Dr. Florian shares the regulatory aspects of the technology.
\xa0
[22:57]
Dr. Florian explains the need for different printers and software.
\xa0
[29:46]
Dr. Florian describes the challenges of the software used.
Dr. Florian then ends with his encouraging remarks.
\xa0
\xa0
Killer Resources
\xa0
Take the first step to your 3D Printing journey.
\xa0
Register for the upcoming course on Introduction to 3D Printing.
\xa0
Visit the resources section of our website www.surgeonsin3dprinting.com.\xa0